How To Build A Computer

You know what I was able to overcome the exciting feeling to have a new computer? Make your own PC!

Making your own computer from scratch is not only fun to do, but also less expensive. You can choose the parts you want to use a computer. This will give you the control to balance the price and the quality of the newly assembled PC.

Before we show you the steps, here are the necessary elements of the computer you need to buy:

• •CPU Cooler

• •Memory on the motherboard

• •Graphics

• •Hard Drive

• •CD-ROM or DVD

• •Floppy Drive

• •Sound Card

• •Computer Case

• •Power

• •Monitor

• •Keyboard

• •Mouse

Steps to make your computer:

Step 1

The computer case includes motherboard spacers and screws. This helps put the motherboard into the case. Mount the spacers in the corners and the holes on the right. It must correspond with the holes in the motherboard.

If your motherboard has a connector different mode for the case of I / O (input / output) screen, use the plate with the motherboard. Mount inside the case.

Now, to install the processor, lift the lever on the CPU (processor) socket. Processor pins are made in a way that you can put the CPU into the socket in only one direction. Therefore, if you do well, which can easily adapt.

Hold the processor down and close the lever. Before installing the CPU cooler, put the thermal compound on top of the CPU (central).

Step 2

Install the processor cooler over the CPU. Press lightly. Cut the heat sink for the processor socket. Set the heat sink is a fan power to the fan header on the motherboard. It is usually labeled "CPU FAN 1".

Insert the memory module on the long wall called DIMM. Lock both tabs and push the memory down. The clips on the sides slots needs to close. Gently push the motherboard against the shield I / O Put in and tighten the screw. Do not force it.

The brown slot nearest the processor is the AGP slot for video card. Replace the video card, even in the supplied cradle. Screw the card into place. Make sure your AGP card is positioned correctly.

At the corner of the motherboard, you can see two rows of needles. Connect the case leads to pins. These tracks are typically labeled. Read the manual of your motherboard. See what brand goes to which set of legs.

Step 3

Now install the floppy drive, CD / DVD and hard drive. The motherboard usually has two IDE channels, which supports 2 devices. If you install two IDE devices on the same cable, you must be a primary "master" and the second is a "slave".

This is the same procedure for the CD / DVD. Search your hard drive and CD-ROM drive manual for correct jumper settings. You should do this before you screw unit in place.

Connect the hard drives of different channels, CD-ROM. Floppy controller is made shorter than the IDE controller.

Make sure the side of the IDE cable that has a stripe of red lines with Pin1.

Finally, connect the main ATX power cable and connect all the players with food. If you have more cases of refrigerators can also be connected.

Now, connect your monitor, keyboard, mouse and speakers in the rear of the case. Plug the power cord to power. Check the correct installation before the first start.

Now you can show your friends your first single computer.

Ranking: 5